How to Make Beef Jerky Without a Dehydrator =========================================== Beef jerky can be made at home without needing any fancy equipment such as a dehydrator. With minimal adjustments a home oven can be used, which can actually dehydrate a greater amount of food at once than most store bought dehydrators. ![Beef Brisket](pics/sm/brisket-intro.jpg) ![Beef Jerky](pics/sm/finished-beef-jerky-intro.jpg) Select Meat ----------- Any meat can be used to make jerky, but it makes sense to purchase an inexpensive cut since you won't need the tenderness of an expensive cut like a filet mignon. Brisket is a good choice. ![Beef Brisket](pics/sm/brisket-intro.jpg) Trim Fat -------- Trim off any fat on the meat. ![Fat on Beef Brisket](pics/sm/brisket-fat.jpg)![Brisket Fat to Trim](pics/sm/brisket-fat-to-trim.jpg) Once I took the beef out of the supermarket package, I found they had deliberately hidden a big sheet of fat on the bottom. Try and avoid this when shopping, but otherwise trim it off. (I have since been educated that the fat is intentional for roasting to retain moistness). ![Trim Fat](pics/sm/trim-brisket-fat.jpg) ### Optionally Save trimmed fat ### Left over fat can be frozen and when you have several pounds saved up can be thawed, ground, and rendered clean. The rendered fat can be used in cooking, traditional soap making, or other uses. ![Brisket Fat Rolled Back](pics/sm/brisket-fat-rolled-back.jpg)![Freeze Beef Fat](pics/sm/freeze-beef-fat.jpg) Partially Freeze Meat (optional) ------------------------------ If you aren't in a rush, placing the meat in a freezer for a couple hours will firm it up and make slicing it much easier. It will cut your slicing time in half and allow you to have more consistent slice widths. This does not affect the end result greatly and is largely a matter of personal preference. ![Wrap brisket to freeze](pics/sm/wrap-brisket-to-freeze.jpg)![Wrapped Brisket](pics/sm/wrapped-brisket.jpg) Slice Strips ------------ #### Slice Against the grain Slice the meat against the grain. The "grain" of the beef are the layers the meat is in. If you slice *with* the grain, you will be leaving them fully intact, so when you go to chew the meat your teeth have to do all the work at breaking up the fibers. If you slice *against the grain*, the knife has done the work and fibers are very small so you don't have as much chewing to do. #### Slice width Slices 1/8th to 1/4 inch thick are appropriate. The thinner the strip the less time it will take to dehydrate, and the thicker the strip the "chewier" your jerky might be. ![Slice Beef Against the Grain](pics/sm/slice-beef-against-the-grain-diagram.jpg)![Pile of sliced beef brisket](pics/sm/brisket-mountain.jpg) Marinade/Season the Meat ------------------------ Homemade jerky tastes very different from store bought. It tastes like *real meat*! #### Minimal seasoning A simple marinade of salt, pepper, water and vinegar can be used to bring out the flavor of the original cut of meat. I recommend trying this for the first run so you can adjust your recipes in the future #### BBQ seasoning If you have a favorite BBQ sauce, use that and dilute it with water at about a 1:2 ratio (Use 2-3 times as much water as sauce). Once the water evaporates off, the flavor will concentrate back onto the jerky. Marinate 1 hour to over night. You may want to add some additional salt depending on your tastes. ![BBQ Marinade](pics/sm/bbq-marinade.jpg)![Dilute Marinade](pics/sm/dilute-marinade.jpg) Line oven with foil ------------ This step is optional, but only if you prefer scrubbing burned on BBQ sauce from an oven. Use the foil. ![Aluminum foil in oven](pics/sm/line-oven-with-foil.jpg) Arrange strips ------------ Remove the oven cooking grate and arrange the beef strips on it. Doing this over a sink is a good idea because the marinade will be dripping off immediately, so less will drip in the oven. ![Beef strips on oven grate](pics/sm/arrange-beef-strips.jpg)![All Beef strips on oven grate](pics/sm/arrange-beef-strips2.jpg) Start oven and vent door ------------------------ Set the oven temperature as low as it will go. Ideal temperature is 140 degrees farenheight, which will dehydrate the food without cooking it. My oven only goes to 170 (F) degrees but works fine. Using a wooden spoon (no plastic! it could melt), prop open the oven door to vent. This lets air circulate and dehydrate the food faster. If you have an oven circulation fan, this could be helpful as well but I have not used one before. It will take 2-6 hours to make the jerky depending on slice thickness and oven temperature. My batches are around 4 hours long. ![Set oven temperature](pics/sm/set-oven-temperature.jpg)![Vent oven door with spoon](pics/sm/vent-oven-with-wooden-spoon.jpg) Test for doneness ------------ After about 2-3 hours check for doneness. Take a piece of jerky and bend it. If it bends easily or feels juicy it needs more time. When it starts to stretch or tear the fibers when you bend it it is near done. You can let a strip cool out of the oven for 10 minutes and do this test again. When warm the jerky is easier to bend, so cooling it first can let you know if it is dry like jerky. When I did my first batch, I thought it was done and took it out of the oven. After nibbling on it and testing it out after cooled for 30 minutes I decided it needed more time. No big deal, back into the oven. ![Beef in oven](pics/sm/put-beef-brisket-into-oven.jpg)![Drips from dehydrating beef](pics/sm/drips-from-dehydrating-beef-brisket.jpg) Remove and let cool ------------ Remove and let the jerky air dry. Don't package it immediately. Give it 24 hours to fully to dehydrate at room temperature, but you can start eating it right away. ![Finished beef jerky](pics/sm/finished-beef-jerky.jpg)![Finished beef jerky close up](pics/sm/finished-beef-jerky-closeup.jpg) ![Air dry and cool jerky](pics/sm/air-dry-and-cool-beef-jerky.jpg)